235 x 235 PEi Flex plate, double sided. Smooth STARRY PEO on one side and textured powder coated PEi on the other.

STARRY AFFECT on print on smooth side.

1 x PEi double sided flex plate, smooth/textured.

1 x magnet base

Do not use acetone to clean the powder coated side.. IPA alcohol 90%+ is fine for both sides.

* When printing filament with with a heat deflection temperature below 60c-80c (such as PETg) the temperature of the hotbed is set above 60c and it's recommended to remove the upper glass cover plate to avoid heat creep that can cause filament to soften which can lead to clogs or abnormal extrusion.

* When printing filament with a heat deflection temp below 60c (such as PLA, PVA,TPU). The hotbed is set above 45c and recommend to open the glass front door & remove the upper glass cover plate to avoid heat creep that can cause filament to soften which can lead to clogs or abnormal extrusion.

* Regularly clean the print surface with 90%+ IPA alcohol and / or warm soapy water (dish soap) to get rid of any dust or fingerprints, which may cause adhesion problems.

* Do not clean with acetone, it will damage the PEI surface.

* Always wait a few minutes before removing finished prints to allow them to cool for easier print removal.

* Smooth PEi may require a release agent (glue stick etc) when printing PETG , ABS etc

Suitable for 235 x 235 beds. Artillery Hornet, Genius, Genuis plus. Ender 3 etc